Molemi IoT
  • Space farming using food computers for sustainable farming
  • Introduction to Arduino
    • Introduction to Electronics
    • The Breadboard
  • Controlling LEDs with an Arduino
    • The Code
    • Adding a button to control the LEDs
      • The Code
  • Introducing Sensors
    • The CO2 and air quality sensor
    • The Code
      • Explaining the Code
    • Light Intensity Sensor
  • Introducing the NodeMCU
    • Getting Started
      • A simple test for ESP8266
        • The Code
    • A light bulb switch using NodeMCU and the Blynk app
      • Setup Blynk on your Smartphone
      • The Code
    • Controlling a Centurion gate Motor with NodeMCU a 2-channel relay
      • Installing Blynk in Arduino IDE
    • Read and display the water flow sensor on Blynk
      • Setting up Blynk
      • The Code
        • Explaining the code
    • Read and Display temperature sensor readings with NodeMCU.
      • Installing libraries for DS18B20 temperature sensor.
      • Displaying the sensor readings on the serial port
        • Getting temperature readings from different DS18B20 sensors.
          • The Code
            • Display sensor readings on a web server
              • Build the web server
                • Designing and building the web page
                • The Code
    • Display the DHT11 sensor reading on a web server using NodeMCU.
      • Monitoring Room Temp & Humidity using Blynk
      • Installing DHT library on the ESP8266
        • Installing the Asynchronous Web Server library
          • The Code
          • Designing and building the web page
  • Data Science for Farming
    • Getting Started with Colaboratory
    • Introduction to Python for DS using Colab
  • Machine Learning for Farming
  • Molemi Personal Food Computer
    • Bill of Materials
  • Setting up WaziGate on a Raspberry Pi
  • Setting up DHT11 on Raspberry Pi
  • Using Telegram To Control Outputs
Powered by GitBook
On this page

Was this helpful?

  1. Introducing the NodeMCU
  2. Read and Display temperature sensor readings with NodeMCU.

Installing libraries for DS18B20 temperature sensor.

PreviousRead and Display temperature sensor readings with NodeMCU.NextDisplaying the sensor readings on the serial port

Last updated 5 years ago

Was this helpful?

To start using the DS18B20 temperature sensor you need to install the library for it in order to be able to allow the NodeMCU board to communicate with it.

To be able to communicate with the DS18B20 sensor you will need to install the One Wire library and the Dallas Temperature library.

On your computer open the Arduino IDE software and open the library manager as follows Sketch > Include Library > Manage Libraries. and then type "onewire" in the search box and select one wire library by Paul Stoffregen:

The next step is to search for "dallas temperature" and then install the library by Miles Burton:

Installing OneWire library (randonnerdtutorial.com)