Reacoda
  • Reacoda Learning Material
  • Introduction to Arduino
    • Controlling LEDs with an Arduino
  • Introduction to Python Programming
    • Python for beginners Bot
  • Robotics and Automation
    • What is automation?
    • What is robotics ?
    • What is 4IR ?
    • Introdution to electronics: Electrical Circuits ?
  • Guidelines for creating tutorials for people with limited to no internet access
  • Arduino Classes using TinkerCAD
    • Wiring Components
    • Adding A component
  • IoT Workshop
    • Python Basics Quiz
  • Control LEDs using NodeMCU and microPython - Part 1
    • Using microPython on Thonny IDE to blink a built-in LED
    • Using the Pulse Width Modulation (PWM) with microPython.
  • SkillShare Class
  • Introduction to Robotics (Yabasadi)
Powered by GitBook
On this page

Was this helpful?

  1. Arduino Classes using TinkerCAD

Wiring Components

This activity is going to demonstrate how to wire components in TinkeCAD.

PreviousArduino Classes using TinkerCADNextAdding A component

Last updated 5 years ago

Was this helpful?

  1. The first thing we need to do is to connect the wires from the battery to the circuit: Hover over the positive terminal of the battery until you see the positive label. click on it and then hover over the "+" on the breadboard and then click on it. Click on the wire and change the color to red.

  2. Hover over the black terminal of the battery and then click on it whenever you see the negative label. Hover over the breadboard on the "-" and click on it. Change the color of the wire to black.

  3. Click the "Start Simulation" button.